Wall Mount Touch Panel RGB LED Controller, 12-24V DC
Dimensions: 3.45” x 3.38” x 1.42”(88 mm x 86 mm x 36 mm)
Output Frequency: 3225 Hertz Input Voltage: 12-24 VDC
Maximum Load: 4A per channel, 12A total
Maximum Power: 144W/288W (12VDC/24VDC)
This wall mount touch panel RGB LED controller is extremely easy to wire. Simply apply 12 or 24 VDC (based on the requirements of the LEDs you are powering) to the terminal blocks labeled INPUT V+ and V-. Next apply the leads of the RGB strip to the terminal blocks labeled OUTPUT V+, R (red), G (green), and B (blue). A maximum load of up to 4A of LED strip or modules can be connected to each OUTPUT port.
Operation Turn the controller on or off using this power button.
The mode button allows you to access preset color functions. Once a mode is activated, pressing this button again will access the next mode in series. The pre-set modes are listed below. Once the last mode is reached, pressing the M button again will cause you to cycle back to the beginning of the list.
To turn the beeping function on or off, press the M button for several seconds, until you hear a long beep.
This button allows you to increase the speed of modes 8-10, and increase the brightness at all other times. There are 24 levels of speed and brightness available.
This button allows you to decrease the speed of modes 8-10, and decrease the brightness at all other times. There are 24 levels of speed and brightness available.
The touch wheel allows you to easily select the perfect color, with 64 distinct touch points.